Would you like to learn how to enable Cisco Telnet remote access using the command-line? In this tutorial, we are going to show you all the steps required to configure the Telnet remote access on a Cisco Switch 2960 or 3750 using the command-line.

Cisco Switch Playlist:

On this page, we offer quick access to a list of videos related to Cisco Switch.

Don't forget to subscribe to our youtube channel named FKIT.

Cisco Switch Related Tutorial:

On this page, we offer quick access to a list of tutorials related to Cisco Switch.

Tutorial - Enable Cisco Telnet Remote Access

First, you need to access the console of your Cisco Switch.

In our example, we are going to use an Opensource software named Putty and a computer running Windows.

The Putty software is available on the putty.org website.

After finishing the download, run the software and wait for the following screen.

Putty windows

To access the console of a Cisco Switch model 2960 or 3750, you will need to select the Serial Connection category and use the following options:

• Connection type: Serial
• Serial line: COM1
• Speed: 9600

If COM1 does not work you will need to try to use COM2, COM3, COM4 or the next.

cisco switch terminal settings

Using either the console, telnet or ssh, connect to the command-line of your switch and log in with a user who has administrative privileges.

On the prompt screen, enter the administrative login information.

After a successful login, the console command-line will be displayed.


Use the enable command to enter the privilege mode.

Switch> enable

Use the configure terminal command to enter the configuration mode.

Switch# configure terminal

Create a user account to the remote users.

Switch(config)# username kakarot privilege 15 secret kamehameha123
Switch(config)# username yamcha privilege 1 secret lostbuma123

In our example, the kakarot user has read-write privilege while yamcha has read-only.

Configure the virtual terminal to use local authentication.

Configure the virtual terminals to allow Telnet remote access.

Switch# configure terminal
Switch(config)# line vty 0 15
Switch(config-line)# login local
Switch(config-line)# transport input telnet
Switch(config-line)# exit
Switch(config)# exit

Don't forget to save your switch configuration.

Switch# copy running-config startup-config

You have successfully enabled the Cisco Telnet remote access feature.

You have successfully configured the remote terminals to accept telnet connections.

You have successfully created user accounts with different privilege levels.