Would you like to learn how to do a WAP4410N initial configuration? In this tutorial, we are going to show you how to do the initial IP address configuration on a Cisco WAP4410N access point?
Hardware List:
The following section presents the list of equipment used to create this Ubuntu Linux tutorial.
Every piece of hardware listed above can be found at Amazon website.
WAP4410N Playlist:
On this page, we offer quick access to a list of videos related to Cisco Access Point.
Don’t forget to subscribe to our youtube channel named FKIT.
WAP4410N Related Tutorial:
On this page, we offer quick access to a list of tutorials related to WAP4410N.
Tutorial – Cisco WAP4410N Initial Configuration
Connect your computer to the Cisco WAP4410N access point using a crossover cable and configure the following network address on your computer:
• IP – 192.168.1.10
• MASK – 255.255.255.0
Turn on the WAP4410N and wait 1 minute.
Press the reset button located on the back of your equipment for 15 seconds.
Now, it is time to test the connectivity between the Access point and your desktop.
Open a DOS prompt and try to ping the default IP address of the WAP4410N equipment: 192.168.1.245
C:\> ping 192.168.1.245
Disparando 192.168.1.245 com 32 bytes de dados:
Resposta de 192.168.1.245: bytes=32 tempo=5ms TTL=255
Resposta de 192.168.1.245: bytes=32 tempo=5ms TTL=255
As our next step, we need to access the WAP4410N web interface.
Open your browser and enter the IP address of the WAP4410N.
On the login screen, use the default username and default password.
• Default IP Address: 192.168.1.245
• Default Username: admin
• Default Password: admin
After a successful login, you will be sent to the WAP4410N Dashboard.
The system will require you to change the administrator password immediately.
On the Web interface, access the Wireless menu and select the Basic settings option.
Change the name of your wireless network.
Select the Wireless network mode: B/G/N
On the Web interface, access the Wireless menu and select the Security option.
Select your wireless network name.
Select the WPA2-Personal Security mode.
Configure the desired wireless password and save your configuration.
If you need to change the IP address of the device.
Access the Setup menu and select the Basic setup option.
Change the IP address from DHCP to Static and configure the desired IP address.
Don’t forget to save your configuration.
Congratulations, you have installed the Cisco WAP4410N Access point.
