Would you like to learn how to enable SNMPv3 an HP switch? In this tutorial, we are going to show you all the steps required to configure the SNMPv3 using an HP Switch 1910, 1920 or 5500 using the web interface.
Copyright © 2018-2021 by Techexpert.tips.
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means without the prior written permission of the publisher.
Equipment list
Here you can find the list of equipment used to create this tutorial.
This link will also show the software list used to create this tutorial.
HP Switch Playlist:
On this page, we offer quick access to a list of videos related to HP Switch.
Don’t forget to subscribe to our youtube channel named FKIT.
HP Switch Related Tutorial:
On this page, we offer quick access to a list of tutorials related to HP Switch.
Tutorial HP Switch – SNMPv3 configuration
Open a browser software, enter the IP address of your Switch and access the HP Switch web interface.
On the prompt screen, enter the administrative login information.
Factory default access information:
• Username: admin
• Password: (no password)
After a successful login, the administrative menu will be displayed.
Access the Device menu, and select the SNMP option.
On the SNMP configuration screen, you will have to access the Setup tab.
Access the Setup tab and perform the following configuration:
• SNMP – Enable
• Contact
• Location
• SNMP Version
Click on the Apply button.
Access the Group tab and perform the following configuration:
• Group Name
• Security Level
• ReadView
Click on the Apply button.
Access the Community tab, click on the Add button and perform the following configuration:
• Community Name
• Access Right: Read-only
Click on the Apply button.
Access the User tab, click on the Add button and perform the following configuration:
• Username
• Security Level
• Group name
• Authentication mode
• Authentication password
• Privacy mode
• Privacy password
Click on the Apply button.
Don’t forget to save your switch configuration.
You have successfully enabled the HP Switch SNMPv3 service.
You have successfully configured the HP Switch SNMPv3 service.
To test your HP Switch SNMP configuration, use the following commands on a computer running Ubuntu Linux.
You have finished the configuration.
